Silicon Turnkey Solutions' ESDLAB.com

Latch-up Testing Human Body Model Testing Machine Model Testing Charge Device Model Testing Air Discharge ESD Testing Air contact ESD Testing Electro-Thermally Induced Parasitic Gate Leakage test

Thermo Keytek MK4 Testers Thermo KeyTek MK2 Testers Thermo KeyTek RCDM3 Robotic CDM/ ESD Tester Oryx EX 1100.2016 pin Tester

Submit RFQ-Latchup Submit RFQ-Esd Technical Inquiry

Company Address


	Services
		Latch-up Testing
		Human Body Model ESD Testing
		Machine Model ESD Testing
		Charge Device Model ESD Testing
		Air Discharge ESD Tester
		Air Contact ESD Tester
		Electro-Thermally Induced Parasitic Gate Leakage test

Machine Model Testing

Machine Model is similar to HBM testing. The test equipment is the same, but the test head is slightly different. The MM version does not have a 1,500 ohm resistor, but otherwise the test board and the socket are the same as for HBM testing. Machine Model testing was actually developed in Japan and is a much more severe ESD test that simulates metallic contact between the device under test and charge body.

The following industry standards are used to test devices for Machine Model testing:

EIA/JEDEC JESD22-A115-A
ESD-STM5.2 1999
AEC-Q100-003-Rev E